I530

I530 3.5" Motherboard with Intel® Pentium M/Celeron M Processors, Mini-PCI, LVDS/CRT, DC-IN Power input
Features
  • 3.5" Form Factor (146mm x 101mm)

  • Intel® Pentium M/Celeron M Processors,up to 2.0GHz

  • Intel® 855GME / ICH4 Chipset

  • Integrated CRT/LVDS, shared memory up to 64MB

  • 1 x DDR SODIMM, max. 1GB

  • Integrated Dual Gigabit Ethernet

  • 1 x Mini PCI

  • 2 x COM, 4 x USB 2.0, 1 x Type I/II CF Socket

  • 12V DC-IN power input

  • One Digital I/O
    • Datasheet
    System Specification
    Form Factor3.5"
    Processor SocketSocket 478 FC-PGA/Socket 479 FC-BGA
    ProcessorIntel® Pentium M / Celeron M Processor, up to 2.0GHz
    BIOSAward 4Mbit Flash
    System ChipsetIntel® 855GME / ICH4 Chipset
    System Memory1 x SODIMM, Max 1GB DDR 333
    Ethernet ControllerDual Realtek RTL8110SCL GigaLAN
    I/O ChipsetWinbond W83627EHG
    Serial1 x RS-232, 1 x RS-232/422/485*
    USB4 x USB2.0
    KB / Mouse Connector1 x PS/2
    IDE1 x 44pins IDE
    Expansion Slot1 x Mini PCI
    SDD Interface1 x Type I/II CF socket
    Watchdog Timer256 levels
    I/O Connectors
    Back Side I/O2 x RJ-45(1000 Mbps), 1 x PS/2, 1 x VGA Conn, 2 x USB, 1 x DC-IN power Jack
    Internal I/O pin-header1 x RS-232, 1 x RS-232/422/485*, 2 x USB, 1 x 44pin IDE, 1 x Digital I/O (4 Input / 4 Output)
    Graphic Specification
    Graphic ControllerIntegrated Extreme Graphics 2 Engine
    Graphic MemoryShared momery, max. 64MB
    LVDSDual Channel 18/24-bit LVDS
    Audio Specification
    Audio ControllerRealtek ALC6555.1 Channel Controller
    Ethernet Specification
    Ethernet ControllerDual Realtek RTL8110SCL GigaLAN Controller
    Mechanical and Environment
    Dimensions ( L x W )146 mm x 101 mm ( 3.5" Form Factor )
    Power RequirementIntl Pentium M 2.0 GHz w/ 1GB DDR - 3D MARK, +12V/4A
    Power Input12V DC-IN Power input
    Operating Temperature0 deg.C to 60 deg.C
    Operating Humidity30% to 90% (non condensing)
    CertificationsCE, FCC, RoHS
    Note: All Specifications are subject to change without prior notice!
    *If you use SBC on-board RS485, you need to set appropriate state of RTS line before sending/receiving data in your software program.We offer additional board that can perform auto-direction hardware function.
    		Add to Del.icio.us
    		DIGG this
    		Google bookmark
    		Technorati
    		Yahoo! My Web